The maintenance of the agitation equipment is an extrem […]
The maintenance of the agitation equipment is an extremely important and regular job. It should be closely coordinated with the extreme operation and maintenance. There should be full-time staff on-duty inspection.
Maintenance of the agitation equipment
1. The shaft bears the full load of the negative machine, so a good lubrication has a great relationship with the bearing life, it directly affects the service life and operating rate of the machine, thus requiring the injected lubricating oil must be clean, the seal must be good, the machine's Main oil filling point (1) Rotating bearing (2) Roller bearing (3) All gears (4) Moving bearing, sliding plane.
2. Looseness of newly installed tyres is often subject to frequent inspections.
3. pay attention to the work of all parts of the machine is normal.
4, pay attention to check the wear of the wear parts, always pay attention to replace the worn parts.
5. Put the mobile device's chassis plane, should go out of dust and other things to avoid the machine encountered the material can not be broken when the mobile bearing can not move on the chassis, resulting in serious accidents.
6. If the bearing oil temperature rises, you should immediately stop and check the cause to eliminate it.
7. If the impact sound of the rotating gear during operation should immediately stop and check, and eliminate.
1. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts.
2. the installation should pay attention to the vertical and horizontal body.
3. After installation, check whether the bolts in each part are loose and whether the main door is tight. If so, tighten it.
4. According to the power of the device configuration power cord and control switch.
5. Check is complete, empty load test, test can be normal production.